Home

Products

How to Buy

Company

News

Resources

Support

Contact Us

Use up and down arrows to select available result. Press enter to go to selected search result. Touch devices users can use touch and swipe gestures.
FAQs

FAQs

Q: HOW DO I DETERMINE AN UNKNOWN IP ADDRESS?
Q: How Do I Test an AMCI SSI System?
Q: How Do I Test an AMCI Resolver System?
Q: Using a SMDXXE2 Absolute Encoder
Q: SMD34E2 Removing Main Power
Q: AMCI M12 Cordset Part Numbers, Wiring, and Cross Reference
Q: Why does my stepper motor run erratically?
Q: How Do I Reverse a Resolver's Count Direction?
Q: How can I use the 16 bit data from my Nexus unit with my 32 bit Network Scanner?
Q: What Causes the Resolver Counts to Vary or Jump?
Q: Can I Use Transducers From Other Manufacturers with AMCI Controllers?
Q: How do I choose between Single Turn, Geared Single Resolver, or Dual Resolver Transducers?
Q: What Transducer Cable Can I Use in High Temp or High Flex Appications?
Q: How Do I Calculate the Number of Turns Completed by a Resolver in the PLC?
Q: How do I program my 2600 module to simulate the Group Modes present in the 8500 and 8213 modules?
Q: How Do I program an AMCI SSI Interface Module to work with an Allen Bradley 842A Absolute SSI Encoder?
Q: How Do I Use an AMCI Block Transfer Module in a ControlNet Remote Rack?
Q: How Do I Connect AMCI Stepper Indexers to Rockwell Automation's Ultra 3000 Servo Drivers?
Q: How Do I Wire a Single-Ended Indexer Output to an AMCI Stepper Drive Differential Input?
Q: How Do I Generate "Velocity at Zero" and "Motion Direction" Bits in PLC Ladder Logic?
Q: How Do I Offset the Resolver Position in the PLC?
Q: How do I change the IP address of an AMCI Ethernet IP or Modbus TCP/IP device?
Q: Can I use an AMCI Stepper Module as a Frequency Generator?
Q: How Do I Use Ladder Logic Instructions to Communicate with an Ethernet IP Next Unit?
Q: How can I tell if my SSI sensor is not communicating with my AMCI SSI interface module?
Q: How do I add my AMCI module to a PAC Rx7i system?
Q: How do I address an AMCI Nexus unit in my Modbus TCP/IP network?
Q: Using AMCI’s Device Firmware Update utility